Hello, a new Fonera is out, with 802.11n http://corp.fon.com/en/products/simpl/ http://www.fon.com/it/product/foneraSimplFeatures any news for OpenWRT running on it ? :) Saverio _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware Weitere Infos zu den freifunk.net Mailinglisten und zur An- und Abmeldung unter http://freifunk.net/mailinglisten
Hello, the NanoStation 5 has been replaced by NanoStation _M_ 5. Looks like the old device gets harder and harder to find at shops. I bought a couple of NanoStation M5 but from the official channels looks like this device is not really supported: http://wiki.openwrt.org/toh/start#ubiquiti However, I spotted some firmware images with a particular name: http://downloads.openwrt.org/backfire/10.03.1-rc4/ar71xx/openwrt-ar71xx-ubnt-nano-m-squashfs-factory.bin so this could the image for backfire ? any advice to flash this device ? thanks ! Saverio _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware Weitere Infos zu den freifunk.net Mailinglisten und zur An- und Abmeldung unter http://freifunk.net/mailinglisten
Am 18.12.2010 15:08, schrieb ZioPRoTo (Saverio Proto): > Hello, > > the NanoStation 5 has been replaced by NanoStation _M_ 5. Looks like > the old device gets harder and harder to find at shops. > > I bought a couple of NanoStation M5 but from the official channels > looks like this device is not really supported: > > http://wiki.openwrt.org/toh/start#ubiquiti > > However, I spotted some firmware images with a particular name: > http://downloads.openwrt.org/backfire/10.03.1-rc4/ar71xx/openwrt-ar71xx-ubnt-nano-m-squashfs-factory.bin > > so this could the image for backfire ? > > any advice to flash this device ? > works with pirate firmware. > thanks ! > > Saverio Alex _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware(Continue reading)
Hi, On 18.12.10 15:08, ZioPRoTo (Saverio Proto) wrote: > However, I spotted some firmware images with a particular name: > http://downloads.openwrt.org/backfire/10.03.1-rc4/ar71xx/openwrt-ar71xx-ubnt-nano-m-squashfs-factory.bin > > so this could the image for backfire ? any advice to flash this > device ? yepp, this image works fine on the M5 devices. Just put the nano in recovery mode (push reset, power on, hold the reset button for at least 10 seconds) and thransfer the image using tftp. We tested ap, sta and ad-hoc mode successfuly, but there are some pitfalls you should be aware of: - adhoc is slower thant ap/sta (our test showed ~19MBit/s vs. 27MBit/s on the same test environment) - running olsr on the wan interface (eth1) fails (NLQ is 1, LQ 0). We "fixed" this problem by switching wan (=eth0) and lan (=eth1) in /etc/config/network, but this causes other problems (no dhcp on the lan/eth1 interface, extreme slow wan connections - about 1/10th of the wlan-speed) - there are some regulatory issues as well Especially because of the olsr-issue, we're running AirOS on the M5 devices now. best regards, // melle(Continue reading)
Hallo Wir verwenden in Rosbach noch die "Klasische Firmware", würden allerdings gerne Backfire benutzen. Aber wie können wir unsere Community in den "Freifunk-Wizzard" hinzufügen? Den umständlichen kann man doch keinem User zumuten. An wen müssen wir uns dafür wenden? Gibt es sonst noch irgendetwas zu beachen? Vielen dank im Voraus. Gruß Simon _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware Weitere Infos zu den freifunk.net Mailinglisten und zur An- und Abmeldung unter http://freifunk.net/mailinglisten
On 18.12.2010 18:11, Simon Terzenbach wrote: > Hallo > > Wir verwenden in Rosbach noch die "Klasische Firmware", würden allerdings gerne Backfire benutzen. > Aber wie können wir unsere Community in den "Freifunk-Wizzard" hinzufügen? Den umständlichen kann man doch keinem User zumuten. > An wen müssen wir uns dafür wenden? > Gibt es sonst noch irgendetwas zu beachen? > > Vielen dank im Voraus. > > Gruß Simon Hallo Simon schau dir mal das an: http://luci.subsignal.org/trac/browser/luci/trunk/modules/freifunk/root/etc/config Du musst dann analog zu den anderen Eintraegen im File freifunk einen für eure Community machen und evtl. auch ein externes file (so wie die freifunk_*) files. Du kannst das in OpenWrt in /etc/config/freifunk auch erstmal eintragen und testen. Wenn dann alles ok ist kannst es mir schicken oder ein ticket auf http://luci.subsignal.org/trac/newticket aufmachen. Grüße, soma
(Continue reading)
At Ninux we did some shopping :) Okay, now I have to flash a PicoStation5, and again there is no official advice here: http://wiki.openwrt.org/toh/start#ubiquiti I logged in via SSH in AirOS and I got this info: XS5.ar2313.v3.5.4476.091013.1757# cat /proc/cpuinfo system type : Atheros AR531X processor : 0 cpu model : MIPS 4Kc V0.10 BogoMIPS : 179.81 wait instruction : yes microsecond timers : yes tlb_entries : 16 extra interrupt vector : yes hardware watchpoint : yes VCED exceptions : not available VCEI exceptions : not available XS5.ar2313.v3.5.4476.091013.1757# So I guess the correct firmware could be this one ? http://downloads.openwrt.org/backfire/10.03.1-rc4/atheros/openwrt-atheros-ubnt5-squashfs.bin thanks Saverio _______________________________________________(Continue reading)
> - running olsr on the wan interface (eth1) fails (NLQ is 1, LQ 0). We > "fixed" this problem by switching wan (=eth0) and lan (=eth1) in > /etc/config/network, but this causes other problems (no dhcp on the > lan/eth1 interface, extreme slow wan connections - about 1/10th of the > wlan-speed) Signed-off-by: Alexander Couzens <lynxis@...> --- .../ar71xx/files/arch/mips/ar71xx/mach-ubnt.c | 1 + 1 files changed, 1 insertions(+), 0 deletions(-) diff --git a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ubnt.c b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ubnt.c index 5b95264..600d17a 100644 --- a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ubnt.c +++ b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ubnt.c <at> <at> -270,6 +270,7 <at> <at> static void __init ubnt_nano_m_setup(void) { ubnt_m_setup(); + ar71xx_eth1_data.has_ar7240_switch = 1; ar71xx_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_RMII; ar71xx_eth1_data.speed = SPEED_1000; ar71xx_eth1_data.duplex = DUPLEX_FULL; -- -- 1.7.2.3 _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware(Continue reading)
Hi, On 18.12.10 22:22, lynxis wrote: >> - running olsr on the wan interface (eth1) fails (NLQ is 1, LQ 0). We >> "fixed" this problem by switching wan (=eth0) and lan (=eth1) in >> /etc/config/network, but this causes other problems (no dhcp on the >> lan/eth1 interface, extreme slow wan connections - about 1/10th of the >> wlan-speed) > Signed-off-by: Alexander Couzens<lynxis@...> > + ar71xx_eth1_data.has_ar7240_switch = 1; wow, thanks for the hint, I'll test this fix tomorrow and report the results :) viele Grüße, // melle -- -- xmpp: melle@... passion: http://mellenthin.de F489 2C4F E8C2 9A15 DBCB mission: http://freifunk-potsdam.de 127C 81B6 FDC3 7C1A FF85 pubkey: http://mellenthin.de/key.txt _______________________________________________ WLANware mailing list WLANware@... Abonnement abbestellen? -> https://freifunk.net/mailman/listinfo/wlanware Weitere Infos zu den freifunk.net Mailinglisten und zur An- und Abmeldung unter http://freifunk.net/mailinglisten
Hi, On 18.12.2010 22:22, lynxis wrote: >> - running olsr on the wan interface (eth1) fails (NLQ is 1, LQ 0). We >> "fixed" this problem by switching wan (=eth0) and lan (=eth1) in >> /etc/config/network, but this causes other problems (no dhcp on the >> lan/eth1 interface, extreme slow wan connections - about 1/10th of the >> wlan-speed) >> > .../ar71xx/files/arch/mips/ar71xx/mach-ubnt.c > + ar71xx_eth1_data.has_ar7240_switch = 1; Ok, this fixes the problem partially :) Now the interface comes up, olsrd detects the neighbour on eth1/wan and LQ/NLQ is getting better and better... until: Nov 26 21:03:43 10-22-7-160 user.warn kernel: ------------[ cut here ]------------ Nov 26 21:03:43 10-22-7-160 user.warn kernel: WARNING: at net/sched/sch_generic.c:261 0x801f7e04() Nov 26 21:03:43 10-22-7-160 user.info kernel: NETDEV WATCHDOG: eth1 (ag71xx): transmit queue 0 timed out Nov 26 21:03:43 10-22-7-160 user.warn kernel: Modules linked in: ohci_hcd nf_nat_tftp nf_conntrack_tftp nf_nat_irc nf_conntrack_irc nf_nat_ftp nf_conntrack_ftp xt_HL xt_hl xt_MARK ipt_ECN xt_CLASSIFY xt_time xt_tcpmss xt_statistic xt_mark xt_length ipt_ecn xt_DSCP xt_dscp Nov 26 21:03:43 10-22-7-160 user.warn kernel: Call Trace:[<80068374>] 0x80068374 Nov 26 21:03:43 10-22-7-160 user.warn kernel: [<80068374>] 0x80068374 Nov 26 21:03:43 10-22-7-160 user.warn kernel: [<8007cf1c>] 0x8007cf1c Nov 26 21:03:43 10-22-7-160 user.warn kernel: [<801f7e04>] 0x801f7e04(Continue reading)
RSS Feed25 | |
|---|---|
15 | |
10 | |
11 | |
27 | |
2 | |
20 | |
7 | |
10 | |
1 | |
3 | |
20 | |
9 | |
21 | |
41 | |
8 | |
1 | |
1 | |
9 | |
1 | |
1 | |
5 | |
27 | |
50 | |
6 | |
18 | |
12 | |
4 | |
7 | |
6 | |
29 | |
12 | |
143 | |
31 | |
29 | |
8 | |
15 | |
1 | |
1 | |
9 | |
5 | |
5 | |
21 | |
21 | |
1 | |
5 | |
2 | |
5 | |
31 | |
2 | |
2 | |
27 | |
18 | |
20 | |
29 | |
31 | |
51 | |
35 | |
39 | |
33 | |
66 | |
76 | |
64 | |
62 | |
104 | |
28 | |
41 | |
83 | |
67 | |
77 | |
87 | |
62 | |
115 | |
255 | |
90 | |
217 | |
193 | |
36 | |
12 | |
67 | |
105 | |
45 | |
146 | |
94 | |
321 | |
174 | |
164 | |
126 | |
65 | |
92 | |
74 | |
122 | |
313 | |
154 | |
101 | |
78 | |
89 | |
52 | |
49 | |
40 | |
48 | |
77 | |
193 | |
27 |
